JRC JLN-205MK2, Quick Reference

Page: 69 / 218

5-3
5.2 Alarm
Check the alarm details referring to the list shown below.
Alarm List
1) Common
Message
Number
Message Contents Alarm Causes
45 ROM[1] Flash ROM Deletion, Write Error (ROM[1])
46 ROM[2] Flash ROM Deletion, Write Error (ROM[2])
47 ROM[3] SEEPROM Deletion, Write Error
48 RAM RAM Read, Write Error
49 SIO[0] Serial Port Error (SIO[0])
50 SIO[1] Serial Port Error (SIO[1])
51 SIO[2] Serial Port Error (SIO[2])
52 SIO[3] Serial Port Error (SIO[3])
53 SIO[6] Serial Port Error (SIO[6])
- No Sensor Data Sensor periodic input not possible (No data)
- Sensor Data Invalid
Sensor information unobtainable (Position, Time,
Course, etc.)
2) MID
Message
Number
Message Contents Alarm Causes
2/3/7 SOG/STW/SOG(LOG) Speed alarm occurs
10 TRIP Trip alarm occurs
17 WATER TEMP Water Temperature alarm occurs
18 DEPTH Depth alarm occurs
19/20 TWS/AWS Wind alarm occurs
21 AIR TEMP Air temperature occurs
22 PRESSURE Pressure alarm occurs
23 HUMIDITY humidity alarm occurs
3) Doppler Log
Message
Number
Message Contents Alarm Causes
63 STW Lost The vessel speed cannot be computed.
3/4/7 STW/SOG(GPS)/
SOG(LOG)
The vessel speed is within the alarm range that is
set.
10 TRIP
The trip value is within the alarm range that is set.
54 NG:URT Data Lost
URT Data is lost.
55 NG:Disp RxT Data The display data cannot be obtained in the display
unit.
56 NG:Proc RxT Data
A measurement condition is not set in the processor.
57 NG:Tmnl TxD TB
There is no display data to the display unit on the
terminal in the distributor.
58 NG:Tmnl TxD Pin There is no display data to the display unit in the
distributor.
59 NG:Tmnl RxD Pin Signals from the display unit are not delivered to the
distributor.
60 NG:Tmnl TxP Pin There is no signal to the processor in the distributor.
61 NG:Tmnl TxP TB There is no signal to the processor in the terminal of
the distributor.
62 NG:Tmnl RxP Pin Signals from the processor are not delivered to the
distributor.