GPS Navigator J-NAV500
41
4.9 Navigation using direct route [GOTO]
A registered waypoint number can be selected as a direct destination by pressing
and entering
a waypoint number. The
function is available in the following four main display modes:
•
[
POSITION
]
,
[
NAVIGATION
]
,
[
CDI
]
and [PLOT
]
display modes
The procedure to make direct route selection is the same in four display modes. In the example
below, shows how to do this from the [CDI] display mode.
(1) Press
.
The
[
DIRECT ROUTE
]
display mode appears and
[
GOTO
WPT_ _ _
]
on the second line is highlighted.
(2) Select the number of the desired waypoint in registerd waypoints.
Example: To set 050
Turn
until 050 is displayed and press
to confirm the
selection.
You can now use the [CDI] display mode to steer you towards the selected waypoint.
Canceling a direct route
To cancel a direct route (or a route plan in operation), press
and enter waypoint number [000].
To enter a new direct route, perform steps (1) to (2) above.
When a direct route is used in the plot display mode, press the
to display the waypoint
numbers beside the waypoint symbols.
Summary of Contents for J-NAV 500
