GPS Navigator J-NAV500
24
4.2 Turning the unit on/off
•
Press
to turn on the unit.
•
Press
and
simultaneously to turn off the unit.
Display changes when the unit is turned on
When the unit is turned on, the displays are shown in the order given below: When position fixing is
completed, the
[
POSITION
]
display is shown.
•
Position fixing the first time the navigator is used or after a master reset takes about 20
minutes. (Subsequent position fixing takes about 1 minute.) To shorten this time, perform
the operation described in Section 4.19.2, Initializing GPS/DGPS receiver.
•
For information on data error display, see the message list in Appendix A .
Master reset
This navigator is equipped with the following reset functions. For example, if the internal battery or the
ROM IC is replaced, a master reset would have to be performed.
When resetting the navigator, perform Initializing GPS/DGPS receiver as described in section 4.19.2
when correcting for local time.
1.
Soft reset
This reset clears all data except registered waypoints and route plans.
•
Key operated soft reset
Press the
key while holding down the
key.
•
Menu selected soft reset
See Section 4.22, “To perform a master reset.”
2.
Hard reset
This reset clears all data including registered waypoints and route plans.
•
Menu selected hard reset
See Section 4.22, “To perform a master reset.”
[Self-test result]
[Version]
GPS status information
After position fixing
Summary of Contents for J-NAV 500
