DGPS224(JLR-4341)
9/20
3.5 NMEA Version Switching
When the equipment is shipped from the factory, the NMEA output version is set to the version 1.5. If
you want to change the output data, please carry out the following procedure:
1. Connect pin 4 and pin 5 of the connector.
2. Turn on the DGPS224.
3. The output data is switch.
(If procedures 1-3 are repeated, the output data is switched to NMEA0183 Ver1.5, Ver2.1, Ver2.3,
IEC
*1
and Beacon correction data sequentially.)
*1:IEC61162-1
SECTION 4 AFTER-SALES SERVICE
If the DGPS224 appears to be defective, check the connection again. If the equipment still
appears faulty after that, stop using the equipment and contact our representative or our sales
office directly.
During the warranty period,
JRC representative or our company replaces your DGPS224
sensor free of charge. This warranty does not cover damage, which has occurred in transit, or
results from alteration, accident, misuse or abuse.
JRC needs to have the following information:
•
Product name, model name, serial number, and purchase
date
•
Detailed failure conditions
•
Name of the company/organization, address, and telephone number
•
Contact
name
For further information on after-sales service, please contact JRC representative,
JRC branch office or sales office. For details, see "Place of Contact" (page 10).
SECTION 5 DISPOSAL
Disposal of the DGPS224
The DGPS224 contains a lithium battery for memory backup.
Observe all the laws and regulations concerned
when you dispose of the GPS sensor.
WARNING
Do not remove the cover of the DGPS224 otherwise it may cause fire,
electric shock, and malfunction. It may also cause poor
waterproofing.
WARNING
Do not throw lithium battery into the fire and overheat it.
It may cause an explosion and ignition.