DGPS224(JLR-4341)
5/20
3.3 Installation Procedure
3.3.1
Installation of the Sensor
The sensor base contains 1 inch 14UNS-2B screw holes. It can be attached to poles with cut male
screws, or off-the-shelf adapters.
(1) When performing attachment, always hold and turn the sensor base. Holding and turning the
radome may result in a large amount of force applied at the junction of the base and the radome,
resulting in damage to the sensor.
Do not apply force to the joint.
Hold and turn the base.
(2) Secure the sensor cable in position with a clamp band as shown below to protect it against damage
due to vibration.
(3) When connecting an extension cable to the DGPS sensor, always seal with self-bonding tape in
order to waterproof the connector, and wrap this section with vinyl tape to protect it.
Radome
Base
Joint
Off-the-shelf
adapter, etc
Off-the-shelf
adapter, etc
Clamp band
Cable
Fig.3-1 Installation
Fig. 3-2 Appearance