P.11
Red
(×
3)
Red
(×3)
Red
(×
4)
● Do not over tighten the ball arms.
Ball arm L9 ( × 3)
Control ball L5.5 ( × 4)
Swash plate 90 (V2)
Setscrew 3 × 3 ( × 3)
● Adjust the swashplate by tightening the setscrew M3 × 3 to
minimize unsteadiness (slop) of the upper plate and lower plate of
swashplate. If there is such unsteadiness, tighten the setscrew M3
× 3 as shown in the figure to the right and adjust them to minimize
the unsteadiness. Be sure to tighten them gradually. If you tighten
them too much, the lower plate may be deformed or may not rotate
smoothly (if you do not feel unsteadiness, you do not have to use
these screws). Note that the unsteadiness of swashplate can not
be completely eliminated. Do not tighten the screws too much.
3-2
SWASH PLATE ASSEMBLY
3-3
MAIN BLADE HOLDER ASSEMBLY
The Main blade holder shape has been changed.
There is no change to the assembly method.
The main shaft has been changed to a hardened main shaft.
There is no change to the assembly method.
3-1
MAIN GEAR INSTALLATION
