Joysway Hobby OFFSHORE LITE WARRIOR V4 Instruction Manual Download Page 5

5

CAUTION!

LUBRICATING DRIVE SHAFT

Please observe the following warnings.

DURING OPERATION

Ensure that all batteries are correctly installed and that the 7.2V Power Pack is fully charged.

Do not operate your Offshore Lite Series in areas with strong currents, in salt water or areas of water with 
large waves.

Do not touch moving parts during operation, especially the propeller. 

Do not let your Offshore Lite Series run aground, as this can cause damage.

If you lose control of your Offshore Lite Series, never wade into deep water or water with strong currents to
retrieve it. First, hold the transmitter as high as you can to try to re-establish control. If this does not work, 
find another way to move closer to the model, but do not endanger yourself in the process!

Care must be taken when handling rechargeable batteries (the Power Pack) to avoid the possibility of injury 
and/or damage to property. Do not short circuit, disassemble or incinerate rechargeable batteries. It is very 
dangerous to disregard these warnings.

GENERAL INFORMATION FOR THE SAFE OPERATION OF YOUR OFFSHORE LITE SERIES

Please follow these simple rules to ensure safe operation and gain the maximum enjoyment from your 
model.

Avoid overloading your model. Never run it in areas where its movement will be restricted, e.g. areas where 
there is pond weed, etc., as this can over stress the motor.

Ensure nothing prevents the smooth running of moving parts.

Do not run your model in confined spaces.

Never run your model in a public space where it might upset or endanger people or wildlife.

Immediately switch ‘OFF’ your model and transmitter if you see lightning or hear thunder. 
Never use your model in the rain.

Do not dismantle or tamper in any way with this R/C vehicle and its transmitter. The manufacturer and distributor 
will accept no responsibility, expressed or implied, for accidents or injuries caused as a result of disassembly, 
modification and/or usage against the Instructions for this product.

Tampering or modification will also invalidate the guarantee.

The transmitter’s range will vary depending on your surroundings and battery strength.Do not operate 
Offshore Lite Series too far away or control will be lost.

Offshore Lite Warrior V4 /Sea Rider V5 RTR Mini EP Racing Boat

Lubricating the flexshaft is vital to the life of the drivetrain. The lubricant
also acts as a water seal, keeping water from entering the hull through 
the stuffing tube. Lubricating the flexshaft, propeller shaft after every
2 or 3 times of operation.

1.  Use the 2mm Allen key to loose the two grub screws of the coupler
     which connects the flexshaft, then slide the flexshaft w/ prop shaft 
     out of the stuffing tube.

2.  Lubricate the flexshaft w/ prop shaft with the water proof marine
     grease,  reinstall the flexshaft w/ prop shaft in reverse order, be sure
     to retighten the two grub screws of coupler.

CARE WITH RECHARGEABLE BATTERIES (THE POWER PACK)

Summary of Contents for OFFSHORE LITE WARRIOR V4







Reviews: