Set the switch to “
” to turn on the low beam
and the taillights.
Set the switch to “
” to turn on the high
beam and the taillights.
Do not use the headlights with the engine turned off for an extended period of
time.The battery may discharge to the point that the starter motor will not operate
properly. If this should happen, remove the batter and recharge it.
Turning light switch
“
/
”
Set the switch to “
” when turn left
Set the switch to “
” when turn right
Four-wheel drive switch “2WD/4WD”
Two-wheel drive ("2WD"): Power is supplied to the rear wheels only.
Four-wheel drive ("4WD"): Power is supplied to the rear and front wheels.
To change from 2WD to 4WD, stop the vehicle, and then set the switch to “4WD”,or
vice versa.
Capstan switch “in/out”
Set the switch to “in” to reel rope in.
Set the switch to “out” to reel rope out
.
Indicator lights
Reverse indicator light "R"
This indicator light comes on when the drive select lever is in the "R" reverse
position.
Battery indicator lighter
“
”
This indicator light comes on when set main switch to “on”
10
