Have in mind
the different polarities of
both cables.
Red
= „
+
“ and
Black
= „
-
“
The other end of the cable must be soldered on to the small board
.
Now you can solder the switch. Have in
mind that the cables must go later on
through the case or attach the switch
beforehand. The ends of the cables at
the switch have to get soldered at the
pads “KEY“. Solder the red cable on to the
rectangle pad and the black one on to the
round pad.
Now you can attach the mainboard with four screws at the bottom of the
case and integrate the inputs and outputs of the power supply.
Ports at the front:
Ports at the back:
Screw the ports at the case and attach the red ports
at the top and the black ones at the bottom like
that:
inside
outside
