Jøtul GF 100 DV II Nordic QT, Installation And Operation Instructions Manual

Page: 24 / 32

24
MANUAL
AUTO
OFF
BLOWER
Optional Blower # 155631
Installation
1. Unpack and check the contents
of the blower kit. Contact your
dealer if any damage is evident
or parts are missing. See fig. 35.
2. Attach the Control Box to the
Snapstat Bracket
using two
#8 x 1/2” sheet metal screws.
As shown in fig. 35, use the pair
of mounting holes appropriate
for your stove.
3. Attach the Control Box to the
studs located underneath the
stove in the middle of the
firebox floor using the two M6
hex nuts and a 10 mm socket
driver or wrench. See fig. 36.
CONNECT THE GAS SUPPLY TO THE
STOVE BEFORE INSTALLING THIS
BLOWER. USE A 90° ELBOW OFF THE
GAS VALVE TO CREATE ADEQUATE
GAS LINE CLEARANCE.
„ „
„ „ „
THIS BLOWER MUST BE ELECTRICALLY
GROUNDED IN ACCORDANCE WITH LOCAL
CODES OR, IN THE ABSENCE OF LOCAL
CODES, WITH THE CURRENT ANSI/NFPA 70,
NATIONAL ELECTRICAL CODE OR CSA C22.1-
CANADIAN ELECTRICAL CODE.
„ „ „ „ „
THIS UNIT IS SUPPLIED WITH A THREE-
PRONG (GROUNDING) PLUG FOR
PROTECTION AGAINST SHOCK HAZARD
AND SHOULD BE PLUGGED DIRECTLY INTO A
PROPERLY GROUNDED THREE-PRONG
RECEPTACLE. DO NOT CUT OR REMOVE THE
GROUNDING PRONG FROM THE PLUG.
„ „
„ „ „
ALWAYS DISCONNECT THE POWER SUPPLY
WHEN PERFORMING ANY SERVICE ON THE
FIREPLACE INSERT.
C C
C C Con
on
on on onten
ten
ten ten tents
ts
ts ts ts
1. Blower
2. Snapstat Wire Harness
3. Control Box
4. Snapstat Bracket
5. Rheostat Knob
6. Snapstat
7.
Mounting Bracket (GF100 DV II ONLY)
8. M6 Flange Nuts, (2)
9. M6 x 12 Hex Bolts, (2)
10. #8 x 1/2” Sheet metal screw, (4)
T TT
T Tools R
ools R
ools R ools R ools Requir
equir
equir equir equired
ed
ed ed ed
• 1/4” socket driver
• 10 mm socket
driver or wrench
Figure 36. Attach Control Switch Box.
Secure with
two Hex Head
Flange Nuts
Snapstat
Figure 35. Blower Kit Components
1
2
6
7
10
9
8
5
3
4
Upper Holes
for GF100
DV II
Lower Holes
for GF200
DV II
10
10