13
Jøtul C 550 Rockland
Figure 13.
Surround Panel assembly
viewed from backside.
Surround Assembly
All fasteners have already been installed in the
appropriate locations at the factory.
You will need to
remove them, attach the parts together as described
below and reinstall the fasteners at those locations.
1. Layout the parts.
Place the castings face down on
a protective surface such as carpeting, blankets or
a sheet of cardboard. See fig. 13.
2. Attach the Breastplates to each other.
Use a 10 mm socket or wrench with two M6 x 10
hex head flange bolts. Adjust the set screw to
obtain parallel alignment of the two plates.
3. Attach the Leg plates.
The Legs must be oriented
with the Hang Tabs on the inside edges as shown in
fig. 12. Use the two remaining M6 x 12 hex head flange
bolts to attach the Legs to the Breastplate assembly.
4. Attach the two Bottom Surround Trim panels
together with the single M6 x 10 hex bolt. Attach
the Trim Mounting Bracket to the back of the
Bottom Trim assembly using the other two M6 x
10 bolts and washers. Orient the bracket as shown
in fig. 14.
T
TT
T
Tools R
ools R
ools R
ools R
ools Requir
equir
equir
equir
equired:
ed:
ed:
ed:
ed:
• 10 mm socket or wrench
5. If appropriate, attach the Extended Surround
Panel
to the firebox. See illustration on page 6.
With the painted side facing out, engage the
hooked tabs on panel with the slots in the
backside of the Surround Brackets on the firebox.
Extend the blower power cord out beyond the
front of surround panel.
6. Attach the Bottom Trim assembly
to the two
studs located in the firebox floor between the
blowers using the M6 nuts already in place.
7. Attach the Surround assembly to the Firebox.
Lift the entire assembly upright and position it in
front of the insert firebox. The four Hang Tabs on
the surround legs must engage with the adjacent
cutouts in the two brackets on the sides of the
firebox opening. The surround will easily engage
with these brackets if the firebox is slightly proud
of the fireplace opening.
8. Check the alignment of the breastplates for
“bowing” and adjust the set screw as necessary.
9. Push the entire unit into position so that the
surround is flush against the fireplace face.
Figure 14. Bottom Surround Trim assembly.
Trim Mounting
Bracket
Right Bottom Trim
Left Bottom Trim
Hang Tabs
Left Leg
Right Leg
Right Breastplate
Left Breastplate
Hang
Tabs
All fasteners are M6 x 10 mm
hex head bolts, pre-installed.
Alignment Set Screw
Front Grille
