8
02.16
Josef Kihlberg JK20-690
7
PREVENTIVE AND CORRECTIVE MAINTENANCE
Before all maintenance tasks on the
stapler always first disconnect it from
the air supply.
To remove a jammed staple.
–
Pry the door open with a screw driver (fig.5/1). It
is three notches in the door to simplified the disas
-
semble.
– Remove the door..
– Clean the canal for defective staples.
– Insert the door into the rear nozzle plate and push
until it clicks shut.
Note! The three notches at the door must be as-
sembled to the front.
7.2 REMOVING JAMMED STAPLES
Fig. 5
7.1 CLEANING THE STAPLER
This stapler does not require special servicing. It only
needs regular cleaning with a non-aggressive (non-
corrosive) cleaner agent. Do not remove any parts for
cleaning purposes!
Check the proper functioning of all safety
devices daily. Make especially sure that:
– the trigger works smoothly, the door stays in place
and the magazine lid does not open itself.
– all screws and nuts are securely tightened.
– the stapler is regularly lubricated (refer to chapter
5.2).
1