Doc No: WG1300BE00 EM Board-UG-R02
Copyright
©
JORJIN TECHNOLOGIES INC. 2014
http://WWW.JORJIN.COM.TW
CONFIDENTIAL
Page 8
below shows the explanations to them in the details.
Items
Key Parts
Descriptions
1
CC3000-WG1300-B0
Module
The core module for performance evaluation. It’s
related feature can be referred to its datasheet.
2
Antenna
It can used for radiated test by reworking cpacitor
to correct pads.
3
J1
It’s a U.FL RF connector via which you can proceed
conducted power test.
4
J14
It is a jumper via which we can swap testing modes,
test mode and operation mode. When pin 2 and
pin 3 are shorted, it runs in operation mode and it
operate in test mode when pin 1 and pin 2 are
shorted.
5
J10
It is a jumper for testing power consumption. It is for
the power for all circuit in this board. In operation
mode, pins of the jumper is shorted. For power
testing, the jumper is removed and ammeter crosses
the pins to do the testing.
6
J12
It is a jumper for testing VBAT_IN power consumption
of WG1300-B0. In operation mode, pins of the
jumper is shorted. For power testing, the jumper is
removed and ammeter crosses the pins to do the
testing.
7
J11
It is a jumper for testing VIO_SOC power
consumption of WG1300-B0. In operation mode,
pins of the jumper is shorted. For power testing, the
jumper is removed and ammeter crosses the pins to
do the testing.
8
J13
Refer to Table 2. For more details on these
through-hole test points
9
J16
Refer to Table 3. For more details on these
through-hole test points
Table 1. TOP-Side Key parts of WG1300BE00 EM Board
