background image

EN

 

EN

6 Installing and Operating the Canopy

•  Position the canopy with the sun visor forward.

•  Insert the canopy attachments into the frame mounts on BOTH sides. Ensure they snap into place. See Figure 6.1.

•  The canopy can be adjusted forward and back, and locked open using the canopy locks on BOTH sides. See Figures 6.2 and 6.3.

•  To close the canopy, unlock the sides, then collapse. See Figure 6.4.

•  To remove the canopy, press the lock buttons on BOTH sides of the canopy and pull up. See Figure 6.5.

3 Installing Rear Wheels

•  Turn stroller upside down.

•  Insert the rear axle through both holes under the stand-on platform. See Figure 3.1.

•  Install the parts in the following order. See Figure 3.2.

   

Small washer

   

Wheel (brake cluster facing inward)

   

Large washer

   

Spring washer

   

Large washer

   

Push snap pin through the hole in the axle until it snaps in place.

•  Push the axle as far as it will go toward the opposite side of the stroller.

•  Next turn the stroller onto its side, with the already assembled wheel toward the floor. Place the axle onto the center of the solid surface of 

the red plastic cap so that the axle is pushing upwards for easier installation. See Figure 3.3.

•  Repeat the installation steps for the other wheel.

•  Push the hubcaps on until they snap in place. See Figure 3.4.

5 Front Wheel Locks

The front wheels can be set to swivel or lock.

•  To lock the front wheels, rotate each wheel set so that it points forward.

•  Pull up on the red locking lever to engage the swivel lock. See Figure 5.1.

•  To unlock the wheels (swivel mode) push down on the lever.

4 Installing Front Wheels

•  Place the front wheel sets onto the front wheel posts until they click in place. See Figure 4.1.

  

•  Pull on the wheel sets to ensure they are installed properly.

7 Attaching/Detaching the Front Tray

•  To attach the front tray, slide the tray onto BOTH red mounts until they snap in place.  See Figure 7.1.

•  To remove tray, press the lock buttons on BOTH mounts and pull forward. See Figure 7.2.

!

WARNING

Possible pinching hazard - Be careful when closing and opening the side hinges so as not to 

pinch your fingers.

!

WARNING

The child tray is not a restraint device. Always secure your child with the restraint system. Never lift the stroller by the child tray. Use caution 

when attaching the child tray when there is a child seated in the stroller.

8 Rear Wheel Brakes

•  Always engage rear brakes before placing child in or removing a child from the stroller.

•  To engage the brakes, push down on either of the red brake levers until the brake snaps in place. See Figure 8.1.

•  Check that BOTH wheel brakes are properly engaged.

•  To release the brakes, lift up on the brake lever. See Figure 8.2.

!

WARNING

Always engage the parking brake when the stroller is not being pushed so that it will not roll away. Never leave stroller unattended, especially 

on a hill or incline, as the stroller may tip over or slide.

Summary of Contents for Caboose Ultralight 85X











Reviews: