Warning!
Take care to test the temperature
of the water flowing from the showerhead,
as it may be hot enough to cause injury.
The water flow can be stopped at any time
by sliding the regulation switch on the
showerhead to the ‘off’ position. The burner
will extinguish.
To reignite the burner, slide the flow
regulation switch to the ‘on’ position, water
will commence to flow and the burner will
ignite within 5 seconds
STORING THE APPLIANCE
1. With the appliance operating turn the
cylinder gas valve in a clockwise
direction to the ‘off’ (close) position. The
burner will continue to operate until all
gas has been bled from the hose and
regulator assembly.
2. Turn off the water supply at the garden
hose tap. Disconnect the ‘quick fitting’
garden hose attachment from the ‘water
inlet’
3. Disconnect the regulator and hose
assembly from the appliance and gas
cylinder and store away
4. Disconnect the showerhead and hose
from the ‘water outlet’, hold the shower
head approximately 1 metre from the
ground and allow all water to drain out
before rolling up and storing away
5. To ensure the draining of water after
use, open the drain valve (ribbed
cylindrical stem next to the water input
valve). Make sure to close the drain
valve once water has been drained.
DISCONNECTING FROM
CYLINDER
1. Check that the appliance is fully
extinguished, the gas cylinder control
valve is in the fully ‘off’ position and all
surfaces are cool
2. Loosen the connection to the gas
cylinder in a clockwise direction.
CARE INSTRUCTIONS
Using warm soapy water with a mild
detergent wipe down all surfaces and areas
of the appliance, taking care not to allow
water to enter the burner outlets
Before each use, check that the screen filter
on the ‘gas inlet’ and ‘water inlet’ pipes is in
place and cleaned of any particles.
•
DO NOT
submerge the appliance in
a sink or bowl.
•
DO NOT
use abrasive cleaners or
bleach.