9) IMPORTANT
: It is important that when
starting the appliance that the gas regulator
is set to the ‘min’ position.
10) IMPORTANT
: It is important that when
starting the appliance that the water
regulator is set to the ‘max’ position.
11)
Turn the gas cylinder on in an anti-
clockwise direction one (1) full turn
12)
Open the valve for our water supply.
Water should not start to flow out of the
shower nozzle as it is still in the ‘off’
position.
13)
When ready, slide the flow regulation
switch on the shower nozzle to the ‘on’
position. Water will start to flow through the
nozzle within a few seconds.
Note:
You should hear a series of clicks
and then the burner should ignite. The
burner flame can be seen operating through
the ‘viewing window’ located at the front of
the appliance.
14)
Adjust the temperature of the water
flowing from the showerhead by turning the
‘gas regulator’ and ‘water regulator’ knobs.
Note:
For higher temperatures increase the
gas regulator control and decrease the
water regulator control