DHBWI-316 www.jonti-craft.com/kydzsuite
|
800.543.4149
Page 10
Assembling Hub Connector Tabs
1. To apply Hub Connector Tabs to a Jonti-Craft furniture
item, first place the Tab Mounting Template included
in your starter kit on the side of the unit as shown.
Depending on where the tabs are to be placed, align
the edge of the template with the front or rear edge of
the furniture item. Mark the holes for the appropriate
height Hub Connector Tabs needed. Remove the
template and set aside.
3. Attach the Hub Connector Tabs by inserting two
#6 – ¾” flat head screws (supplied) through the
holes in each tab and into the drilled holes of the
Jonti-Craft furniture item. Tighten using a medium
Phillips head screw driver.
4. Repeat steps to add Hub
Connector Tabs to opposite
sides or to other units.
2. Drill holes using the
1
/
16
” drill bit from
the starter kit. NOTE: Drill no
deeper than the red of the drill bit.
(½” deep).
Tab
Mounting
Template
Hub Connector Tab
