ENGLISH
5
Safety Precautions
Double insulation
1.
Your electric chain saw is double-insulated for
enhanced protection against electric shock.
A double-insulated tool is designed with two
separate«layers» of electrical insulation, or one
double thickness of insulation between the operator
and the tool’s conducting parts.
Tools that are double-insulated do not use a
grounded (three-pronged) plug. You can plug your
saw into any conventional 120 Volt electrical outlet.
We recommend using a ground fault protector as an
extra safety measure whenever you use your
electric chain saw or any similar power tool.
3.
Safety precautions must be observed when
operating any electric tool. Double insulation
provides added protection only against the result of
an electrical insulation failure inside the saw.
Power supply and extention cable
1.
Power supply.
Use only an AC voltage supply conforming to the
specification on the name plate of the saw.
2.
Extension cable.
The extension cable used to reach the power source
must be :
Specifically marked as suitable for outdoor use.
The W-A marking must be visible on the cable.
Heavy enough (see table) to carry the current
the full length of the cable.
If this conditions is not observed, loss of power
and overheating may damage the cable and the
saw.
Length of cable (ft.)
25
50
Wire gauge
14
14
Cable longer then 50 feet in length is not recommended.
In good condition. Cord insulation must be intact,
with no cracks or deterioration. Plug connectors
must be undamaged.
WARNING!
All electrical repairs to this saw, including housing,
trigger, motor, etc., must be diagnosed and performed
by an Authorized Service Dealer. Operations performed
by untrained persons may lead to the failure of the
double insulation and result in serious injury.
STOP
Safety Precautions for Electric Tools
3.
Important considerations.
a)
Secure the tool cable to the extention cord by
making a knot to prevent disconnection.
b)
Do not abuse cables. Never carry the saw by the
power cable or disconnect it by yanking on the
cable. Keep tool cable and extention cord away from
heat, oil, and sharp edges.
c)
Avoid entanglement. Keep cables clear of
operator, saw chain, and branches at all times.
d)
Inspect electric chain saw and extention cables
before each use. Do not use a unit with a damaged
cable. Take the unit to your Authorized Service
Dealer for repairs.
e)
Guard against electric shock. Avoid body contact
with any grounded conductor, such as metal pipes
or wire fences.
f)
Examine the work area. Keep work area well lit.
Do not expose an electric chain saw to rain.
Do not use this or any other electric power tool in
damp or wet locations. Do not use electric power
tools near flammable liquids or gasses.
SAVE THESE INSTRUCTIONS
CAUTION!
To reduce the risk of electric shock, this equipment
has a polarized plug (one blade is wider than the
other). This plug will fit only one way in a polarized
outlet. If the plug does not fit properly in the outlet,
reverse the plug. If it still does not fit, contact a
qualified electrican to install the proper outlet.
Do not change the plug in any way.
CAUTION!
Vibrations from the prolonged use of hand tools may
cause damage to blood vessel or nerves in the
fingers, hands, and wrists of people prone to
circulation disorders or abnormal swellings.
Prolonged use in cold weather has been linked to
blood vessel damage in otherwise healthy people.
If symptoms occur such as numbness, pain, loss of
strength, change in skin color or texture, or loss of
feeling in the fingers, hands or wrists, discontinue
the use of this tool and seek medical attention.
Users who operate power tools on a continual and
regular basis must keep a close eye on their physical
condition and the condition of the tool.
If you experience any discomfort in your fingers,
hands, wrists or arms, you should discontinue any
work with ALL VIBRATING TOOLS and see your
doctor for medical advice.
