Jonix steel 1C, Use And Maintenance Manual

Page: 19 / 96

19
JO NIX
steel
1
2
3
off on
JO NIX
steel
device is delivered from the factory
equipped with a two-phase wire + earthing of adequate
section (the cable is 2 m long but it is not provided with
the plug). The type of power supply suitable for the
module is 230V/ ~1/ 50Hz.
1) Use the most suitable connector for the sockets in
the installation site.
2) After wiring, connect the device to the power mains.
3) The voltage in the device is indicated by an ON/OFF
luminous switch that will illuminate once turned ON.
6.6 elecTRIcal connecTIons
Before making any connections, make sure
the mains voltage complies with what is
shown on the label.
WaRnInG!
Using power supply that does not meet the requirements requested by the device
could resolve in damaging the device or part of it.
• The electrical connections must be carried out following the instructions provided in this
manual.
• Make sure that voltage and frequency of the electric line correspond to those provided on
the name plate.
• The electrical mains of the
JO NIX
steel
device must be used for the device only, there must
be no other devices powered by the same power line. Do not use adapters, power strips and/
or extension cords.
• Make the connection with cables with a suitable cross-section and in compliance with local
standards.
• The installer must see to it to assemble the device as close to the power disconnector as
possible, according to standards in force and as far as necessary to protect the electrical parts.
6.5 elecTRIcal connecTIons
aTTenTIon! befoRe sTaRTInG anY oPeRaTIon, MaKe sURe THaT THe MaIn
PoWeR sUPPlY Is DIsconnecTeD!
any deficiency or non-conformity with the parameters of the power supply to which
the device is connected might cause damage to the device itself.