10
Operation Instructions
：
1.
Initialization:
long-press the switch of initialization on the circuit board and
do not loosen your finger
until you hear the voice prompt of “……has
cleared”. And the initialization will be finished. At this moment there is not
any effective cards or fingerprints and the administrator password is
123456.
2.
Changing the administrator password:
the default administrator
password is 123456. Press “ * +
+ administrator password +
” to
enter the programming mode. Next, press 8 +
and put in a new
administrator password ending with pressing
. Then put in the
administrator password second time and end with pressing
. The setting
will be finished when you hear a long sound. This administrator password
can also open the lock.
3.
Adding a guest password:
Press “* +
+ administrator pa
”
to enter the programming mode. Next, press 7 +
and put in a 2-digit
user defined password number (from 01 to 99, should be registered in the
form). Then put in a guest password ending up with pressing the
and
repeat this again. The setting will be finished when you hear a long sound.
4.
Adding a guest fingerprint:
Press “* +
+ administrator password +
” to enter the programming mode. Next, press 6 +
and put in a
2-digit user defined number for the guest fingerprint (from 01 to 99, should
be registered in the form). Then put your finger on the fingerprint scanner
till you hear a long sound. The setting is complete.
5.
Deleting all of the guest fingerprints and passwords:
Press “* +
+
administrator pa
” to enter the programming mode. Next, press
1 +
and repeat it again. When the indicator light off, all of the guest
fingerprints and passwords are deleted without changing the administrator
password.
6.
Deleting a guest fingerprint:
Press “* +
+ administrator pa
” to enter the programming mode. Next, press 4 +
and put in the
2-digit fingerprint number you want to delete and end up with pressing
.
Repeat the 2-digit
and the fingerprint is deleted.
7.
Deleting a guest password:
Press “* +
+ administrator password +
