JONARD TOOLS AHC-10, Manual

Page: 6 / 8

Adjust the cutting size and thickness according to previous instruction.
Install the hole cutter into the drill chuck and secure it firmly.
Align the drill bit with the center point of the hole to be cut, then slowly start the drill by turning on the
power of the drill.
In cases of ceiling cutting, press the drill slowly upwards depending on the revolution speed of the
drill. Do not force the cutter by pressing firmly on it. After cutting is finished, always disconnect the
drill from the power supply before removing or adjusting the hole cutter assembly.
In cases of cutting on the ground, the rear side of the cutting surface should be raised off the floor,
press the drill slowly downwards depending on the revolution speed of the drill. Do not force the
cutter by pressing firmly on it. After cutting is finished, always disconnect the drill from the power
supply before removing or adjusting the hole cutter assembly.
To prolong the service life of this tool, always operate it correctly and clean it after each use with a
lightly oiled cloth.
1.
2.
3.
4.
5.
6.
Cuts plywood, plasterboard, acrylic sheets and silicon sheets up to a maximum depths of 27mm
(1.1”).
Drilling on the ground and using the same center point blade on the front and reverse side of the
workpiece, allows a maximum cutting depth of up to 52mm (2.05”).
Maximum cutting diameter: 254mm (10”)
Minimum cutting diameter: 55mm (2.2”)
1.
2.
3.
Use the protection cowl (11) and the drill (1) to stabilize the cutting point.
The protection cowl (11) is injection molded by PC material into one integral part, robust and prevents
chips from flying.
Compatible with various kinds of drills in different revolution speeds. Cuts safely and rapidly.
1.
2.
3.
CUTTING INFORMATION
CUTTING
INSTRUCTIONS
FEATURES