15
16
4. Assemble the support tubes.
4
5. Install mattress.
5
6. Pull the strap through the button hole on the bottom of the travel cot. Wrap the strap around the tube
and fasten the snaps. Repeat on the other corners.
6
!
Push down on all four corners of the mattress to ensure the mattress is secured to the bottom of
the
travel cot.
7. Install mattress, soft side up.
7
It can be used when the installation mode is correct.
!
Take care and pay attention when assembling the cot to prevent injury.
Fold Travel Cot
see images
8
-
14
1. Remove the mattress.
8 9
!
Remove support tube as shown in
21
2. Pull the folding webbing upward.
10
11
!
Do not unlock rails yet. Base of floor must be halfway up before rails will unlock.
3. Unlock all four rails by following these steps.
1) Slightly lift the base.
2) Squeeze the latch button on the rail to release the two tubes.
12
!
Do not force fold.
!
Both tubes must be released for the rail to fold, if rail does not fold completely, please lift the
base of floor higher, and then try again from step 3.
4. Fold the unit, but do not force.
13
14
!
If unit will not fold, look for a partially latched rail. Squeeze the latch button to release the rail.
!
Take care and pay attention when folding the cot to prevent injury.
Cover Travel Cot
see images
15
-
16
Cover unit with carry bag
15
, and then zip together.
16
Bassinet Assembly
see images
17
-
21
Tip
Before setting up bassinet, make sure all rails have become rigid.
1. Zip up the bassinet and secure the zipper head with buckle, then cover it with flap.
17
!
Must zip up the bassinet completely without crevice before using.
2. Assemble the support tubes.
18
3. Place the mattress into the bassinet.
19
!
Place mattress, soft side up.
4. The installed bassinet is shown as
20
5. It can be used when the installation mode is correct.
6. Remove support tube as shown in
21
!
Take care and pay attention when assembling and removing the bassinet to prevent injury.
Changer Assembly
see images
22
-
30
!
The
Changer
can be used independently.
It can be used when the installation mode is correct.
!
Take care and pay attention when assembling and removing the Changer to prevent injury.
Rocker Assembly
see images
31
-
46
!
The Rocker can be used independently.
It can be used when the installation mode is correct.
!
Take care and pay attention when assembling and removing the
Rocker
to prevent injury.
!
Recommended type batteries-alkaline disposables, size D-LR20 (1.5V). NEVER mix battery types.
To use integrated vibration module, slide button to left or right for hi or lo speed.
!
Vibration feature may not be available depending on the model.
!
Batteries not included.
!
The Rocker should not be used for sleeping.
Care and Maintenance
1. The covering material is not removable.
2. Your travel cot can be spot cleaned with a sponge and soapy water.
3. Do not use undiluted neutral detergent, gasoline or other organic solvent to wash the travel cot.
It may cause damage to the travel cot.
4. To wash carry bag, machine wash in lukewarm water and drip-dry. Do not use bleach.
5. At the beach or in the garden, clean sand and grit off your travel cot. Sand in the long rail locks
may cause damage.
6. From time to time, check your travel cot for worn parts, torn material or stitching. Replace or repair
the parts as needed.
7. If the travel cot is not in use for a long period of time, please put it in the shade where your child
cannot access it.
