MOSES BASKET - ASSEMBLY INSTRUCTIONS
YOUR COMPONENTS/ FITTINGS
x 2 Hood Runners
(to fit into the channels in the hood as shown)
dressing
FRONT
BACK
Insert one hood runner
in the
FRONT
channel of
the moses basket hood
.
Insert one hood runner
in the
BACK
channel of
the moses basket hood.
base
hood
PLEASE CHECK YOU HAVE THE FITTINGS SHOWN BELOW.
Please note: The quantities below are the correct
amount to complete the assembly.
STEP 1 - HOOD ASSEMBLY
Insert the hood runners (E) within the two channels
shown in the hood diagram below.
There are channel openings at both ends.
SCREW POSITION
x 2 Screws x 2 Washers x 2 Wing Nuts x 2 Nyloc Nuts
A
B
C
D
E
A
B
C
D
E
SIDE OF BASKET
OUTSIDE OF BASKET
B
F
HOLE IN BASKET
POSITION OF COMPONENTS
INSIDE OF BASKET
Screw should be positioned in the second hole
down closest to the outside of the handle.
2 HOLES DOWN
BASKET HANDLE
INSIDE OF BASKET
HOOD
E
2 X E
STEP 2 - INSERTING SCREW & WASHER
1 X (A) & 1 X (B)
INSIDE OF BASKET
Place the attached screw (A) and washer (B)
through the hole from the inside of the basket
and hold in position. ( See screw position diagram)
Having located the screw with the
washer attached from the inside of
the basket, now attach the
BACK
runner E outside of the basket.
FRONT
BACK
STEP 3 - INSERTING THE RUNNERS
FRONT
BACK
Then attatching the
FRONT
runner
E on top of the
BACK
runner.
It is essential that
BACK
runner
is attached first, followed by the
FRONT
.
HANDLE
INSIDE OF BASKET
Page 1
