©2018 Johnson Level & Tool
13
feature works well if you are in an awkward position or cannot see
the LCD screen. It is also convenient to hold on an important
measurement until you are ready to write it down or cut your material.
It can also be used to set temporary reference values, where the
reference value plus the relative value equals the absolute value.
1. To enable the hold feature, tap . The held value will be frozen
on the main display. The sub-display will now show the relative
value with respect to the held value indicated in the sub-display.
2. To switch the held value currently in the main-display to the
sub-display, tap . The relative value will be transferred to the
main-display with the held value showing in the sub-display.
3. Tap to return to normal measuring mode.
Reset Factory Defaults
If you wish to restore the factory default settings for the level, press
and hold all three buttons – , and – for 10 seconds
while power is on. All customized settings will be reset to the
factory default settings.
Remove and Reinsert End Caps
The rubber end caps can be removed from the
level, making it ideal for cabinetry uses. To
remove each end cap, press while
pulling the end cap back, away from the
level. To reinsert the end cap, press while pushing the end
cap back into the level. Press to make sure the end cap is
fully inserted.
2842i_Manuals 4/27/18 2:09 PM Page 13
