10
©2018 Johnson Level & Tool
1. Tap and simultaneously.
2. Either “HI”, “LO”, “HILO” or “NONE” will flash on the LCD displays,
indicating that you can now set your customized alarm mode.
3. Tap to set the desired alarm mode; continuing to tap will
scroll through the programmable modes.
4. Tap and the rightmost digit will begin to flash, indicating that
it can be configured.
5. Tap to select the digit to set; continuing to tap will scroll
(from right to left) through the following digit options, where the
bolded digit is the one to be set. The options on the left are
applicable if you have set a non-fractional unit of measurement
(degrees, percent, inches/foot – decimal, inches/10 feet – decimal, or
millimeters/meter). The options on the right are applicable if you
have set a unit of measurement of either inches/foot – fraction or
inches/10 feet – fraction.
Note:
Once you have scrolled through
the leftmost digit, the values will be set and the display will revert
back to the preconfigured engineering mode.
Non-Fractional UOM Options
Fractional UOM Options
88.8
8
88.
8
/8
88.
8
8
8
8
.8/8
8
8
.88
8
8.8/8
8
8.88
6. To set the selected digit, press and hold to scroll through the
options of 0 through 9.
7. After five second of inactivity, the level will return to the measuring
mode. Repeat steps 1 through 6 above to set your customized low
(“LO”) limit.
2842i_Manuals 4/27/18 2:08 PM Page 10