TFP658
Page 15 of 16
Step H.
Orientation of paint cap or
wrench “UP” indicator arrow must be
in the 12 o’clock position (horizontal
sidewall sprinkler only). Rotate sprinkler
clockwise a maximum 1 full revolution
to attain proper orientation. Remove
wrench.
Note:
Proper sprinkler orientation may
also be verified by observing position
of sprinkler wrenching notches (Ref.
Figure 13).
Note:
Allow time for sealant to set
before proceeding to Step J: 5 minutes
for LOCTITE 243; 30 minutes for PERM-
ABOND LH056.
Step M.
Remove and discard paint cap
to complete installation.
Note:
Paint cap is single-use only when
painting. Do not re-use after painting.
Step G.
Grasp paint cap or wrench and
rotate sprinkler clockwise until painted
sprinkler body lip (not brass shoulder)
is flush with tool sprinkler body stop
(Ref. Figure 12). Remove installation
tool.
Note:
Proceed to Step H for horizontal
sidewall sprinkler; proceed to Step J for
pendent sprinkler.
Note:
Allow time for sealant to set
before proceeding to Step J: 5 minutes
for LOCTITE 243; 30 minutes for PERM-
ABOND LH056.
Step L.
Paint ceiling or wall to suit.
Note:
Paint cap to remain attached
while painting ceiling or wall.
Note:
Install primed escutcheon for
best painting results (refer to Ordering
Procedure).
Step K.
Orient escutcheon base
flange toward mounting surface, align-
ing escutcheon centerline with sprin-
kler centerline. Push escutcheon onto
sprinkler, engaging body by prongs,
until flange is flush against mounting
surface.
Note:
If ceiling or wall painting is not
intended, remove paint cap to com-
plete installation; If ceiling or wall
painting is intended, proceed to
Step L.
Step J.
Hold covering material in its
installed position and press against
paint cap marking point. Cut clear-
ance hole through covering material
(Ref. Figure 2, Dim. C) using resulting
mark as center point. Install covering
material, assuring sprinkler is centered
in clearance hole.
Note:
Paint cap to remain attached for
marking center point of covering mate-
rial clearance hole.
NOTICE
Install only covering material having
total thickness used in Step A.
Step L
Step M
Step G
Step H
Step K
C
Step J
