20
P5417053-rev.1
2
Point the transmitter towards the receiver
and press “On ” switch.
When the transmitting indicator “
”
ÀDVKHVRQWKH/&'RIZLUHOHVVFRQWUROOHU
the RUN indicator (orange) on indoor
unit is turned ON and the beep sound is
heard. The operation is started.
NOTE:
Do not press “On ” and “Off ” switches
repeatedly (within 3 seconds).
If the switch is pressed frequently, the
controller may not work correctly.
7HPSHUDWXUH)DQ6SHHGDQG$LUÀRZ'LUHFWLRQ6HWWLQJ
Ɣ
The setting condition will be memorized. Therefore, no daily setting is required. Temperature setpoint
DQGDLUÀRZVHWWLQJVZLOOEHUHWDLQHGDIWHUWKHLQGRRUXQLWLVWXUQHG2))DWWKHFRQWUROOHU,QDFDVHZKHUH
the setting change is required, refer to Section 5.2.2.
Stop
Point the transmitter towards the receiver and press
“Off ” switch.
The RUN indicator (orange) on indoor unit is turned
2))DQGWKHEHHSVRXQGLVKHDUG
The indications
RIVHWWLQJWHPSHUDWXUHIDQVSHHGDQGDLUÀRZDQJOHDUH
WXUQHG2))
The operation is stopped.
Ɣ
The indoor unit fan may continue to operate for up to two minutes following the heating cycle to dissipate
residual heat from the indoor unit.
The indications of setting
temperature, fan speed and
DLUÀRZDQJOHDUHWXUQHG2))
Beep
RUN
(TIWM006B21S
to TIWM012B21S)
(TIWM015B21S
to TIWM030B21S)
RUN
The figure shows for
TIWM015B21S to TIWM030B21S.
