S321-IP Network Controller
Hardware Installation
24-10239-480 Rev. F
1
S321-IP H
ARDWARE
I
NSTALLATION
The S321-IP controller communicates with the host via Ethernet. It supports up
to two doors per unit and allows you to configure supervised 4-state inputs and
unsupervised 2-state inputs. The S321-IP controller provides power for the card
reader hardware; it does not provide power for the door locking hardware.
A
BOUT
T
HIS
D
OCUMENT
This document describes S321-IP hardware installation, basic operation, and
maintenance procedures. It is divided into the following sections:
•
Unpacking the Equipment
on page 1
•
Tools Needed
on page 1
•
Mounting
on page 2
•
Description of Signals
on page 5
•
Cable Requirements
on page 7
•
Basic Commissioning
on page 10
•
The S321-IP User Interface
on page 16
•
Technical Specifications
on page 19
•
Maintenance
on page 20
U
NPACKING
THE
E
QUIPMENT
Inspect the S321-IP shipping containers as soon as you receive them, with the
delivery agent present. If a container is damaged, open it immediately, inspect
the contents, and have the agent make note on the shipping document. Check
the purchase order against the packing slips to ensure the order is complete. If
the contents of a container are damaged, notify the carrier and your
Johnson Controls representative immediately. Report any discrepancies to your
Johnson Controls representative. Save the packing materials for possible return
shipments.
Your package should contain the S321-IP controller, connectors set, a CD
containing a set of user documentation, and this manual.
T
OOLS
N
EEDED
Use a small, straight-blade screwdriver to secure wires in the terminal blocks.
