S321-IP Network Controller
Hardware Installation
24-10239-480 Rev. F
15
Configuring and Using a Static IP Address
Use the static IP address if the S321-IP is not connected to a DHCP-
enabled network.
To use a Static IP Address:
1. With the S321-IP unit
powered off
, adjust the DIP settings for Static
IP commissioning as follows: turn switch #6 and switch #8 up (ON).
2. Power on the unit.
3. Adjust the DIP settings for Static IP use as follows: turn switch #6
down (OFF).
4. Log on to S321-IP (see
Logging On and Off
).
5. Assign a new static IP address to the controller using the S321-IP user
interface. (Log in and go to
Network
>
IP
. On the IP page configure
the IP address under the
Static IP Configuration
section. Refer to the
S321-IP Network Controller Configuration and Operation Manual
for more information.)
6. The controller reboots automatically. The new settings will take effect
after the reboot.
Logging On and Off
You can log on to the user interface using the S321-IP controller’s current
IP address or name (in networks with the DNS server).