User Manual: NEO System
44
Rev.0.3
In section 0 can be found a table guide that is used for the calculation of which cabling section
should be implemented in the installation depending on the power and length of the cable.
4.6.1 Line Cabling, Standard Mode
The wiring of the speakers follows a classic scheme. A single cable can connect all of the
speakers that belong to the same amplifier channel. This wiring system can be used with or
without end of lines devices (see 4.6.4). This way, the channel power amplification is distributed
by one single output line.
Figure 46 – Speaker Lines, Standard Mode
4.6.2 Line Cabling, AB Mode
The wiring of speakers using the AB mode allows wiring guide of one same voice evacuation
system, using two different routes. This way, it reduces the risk of completely losing the
connection of a zone which requires voice evacuation in case of damage to one of the lines.
This wiring format can be used with or without end of line devices (see 4.6.4). This way, the
channel power amplification is distributed on both output lines.
