Accessing the installer setting menu
1. From the
Home
screen, press and hold the knob
for 5 seconds to access the main menu.
2. Turn the knob to select the
Settings
icon, then
press the knob to select the
Installer Setting
menu.
Figure 3: Settings icon
3. Turn the knob clockwise to select
Yes
, then press
the knob to confirm.
4. Navigate the Installer Setting menu and select the
preferred options.
Result
To exit the Installer Setting menu, press and hold the
knob for 5 seconds or do not interact with the thermostat
for 60 seconds.
Disposal instructions
Johnson Controls is committed to responsible
environmental stewardship. Please dispose of this
product in accordance with local laws and regulations in
your area. Contact your local waste disposal authorities or
recycling center near you.
Warning information
FCC Part 15C
Warning: Changes or modifications to this unit not
expressly approved by the party responsible for
compliance could void the user’s authority to operate
the equipment. NOTE: This equipment has been tested
and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection
against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that interference will
not occur in a particular installation. If this equipment
does cause harmful interference to radio or television
reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
receiver.
• Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV
technician for help.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired
operation. FCC RF Radiation Exposure Statement
Caution: To maintain compliance with the FCC’s RF
exposure guidelines, place the unit at least 20 cm from
nearby persons.
RSS-247
This device contains licence-exempt transmitter(s)/
receiver(s) that comply with Innovation, Science and
Economic Development Canada’s licence-exempt RSS(s).
Operation is subject to the following two conditions: (1)
this device may not cause interference, and (2) this device
must accept any interference, including interference that
may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d’Industrie
Canada applicables aux appareils radio exempts de licence.
L’exploitation est autorisée aux deux conditions suivantes: (1)
l’appareil ne doit pas produire de brouillage, et (2) l’utilisateur
de l’appareil doit accepter tout brouillage radioélectrique
subi, même si le brouillage est susceptible d’en compromettre
le fonctionnement.
Repair information
If the KONOse fails to operate within its specifications,
replace the unit. For a replacement thermostat controller,
contact the nearest Johnson Controls
®
representative.
Product warranty
This product is covered by a limited warranty, details
Software terms
Use of the software that is in (or constitutes)
this product, or access to the cloud, or hosted
services applicable to this product, if any,
is subject to applicable terms set forth at
www.johnsoncontrols.com/techterms
.
Your use of this
product constitutes an agreement to such terms.
Patents
Patents:
Contact information
Contact your local branch office:
www.johnsoncontrols.com/locations
Contact Johnson Controls:
KONOse Quick Start Guide
3
