Connecting to a power source
Connect the KONOse to a C-terminal, or use the KONOse
with batteries.
Connecting to a C-terminal
About this task:
Important:
Make all wiring connections in
accordance with local, national, and regional
regulations. Do not exceed the electrical ratings of
the KONOse.
1. Turn off the power to the heating and cooling
systems at the circuit breaker.
2. Use the photo of your existing thermostat's wiring
as a guide to wire your KONOse.
3. Reattach the KONOse to the base.
4. Turn the power back on.
Inserting batteries
1. Secure any wires that extend out of the wall so that
the wires cannot make contact with the thermostat.
2. Insert four batteries into the base.
3. Reattach the KONOse to the base.
Setup and adjustments
Device inclusion
About this task:
The thermostat prompts you to pair the device with your
Smart Hub at the initial setup. You can manually pair the
device at any time if you choose to skip this step at the
initial setup.
To manually pair your device, complete the following
steps:
1. From the
Home
screen, press and hold the knob
for 5 seconds to enter the main menu.
2. Turn the knob to select the
Connection
icon, then
press the knob to select the
Inclusion
menu.
Figure 1: Connection icon
3. Turn the knob to select
Add
, then press the knob to
confirm.
The device displays
Scan
on the screen while it
prepares to add to the hub.
4. At the hub portal, click
Add device
.
The device displays
Done
when the device is added
successfully.
If the device did not add successfully, ER:02
shows on the display. Press and hold the
knob for more than 5 seconds to return to the
Inclusion menu and retry to pair the device.
Result
The device automatically returns to the Home
screen after 5 seconds.
Device exclusion
About this task:
To remove the device from your Smart Hub, complete the
following steps:
1. From the
Home
screen, press and hold the knob
for 5 seconds to enter the main menu.
2. Turn the knob to select the
Connection
icon, then
press the knob to select the
Inclusion
menu as
shown in Figure 1.
3. Turn the knob to select
RST
, then press the knob to
confirm.
The device displays
Scan
on the screen while it
prepares to remove from the hub.
4. At the hub portal, click
Remove device
.
The device displays
Done
when the device is removed
successfully.
If the device did not remove successfully,
ER:02 shows on the display. Press and hold the
knob for more than 5 seconds to return to the
Inclusion menu and retry to remove the device.
Changing the control mode
About this task:
To switch the control mode between Heat, Cool, Auto, or
Off, complete the following steps:
1. From the
Home
screen, press the knob once to
turn on the backlight, then press the knob again to
enter the
Control Mode
menu.
2. In the
Control Mode
menu press the knob to select
the preferred mode.
Do not interact with the thermostat for 5 seconds for
the thermostat to confirm the selection.
Figure 2: Control modes
Adjusting the temperature
• From the Home screen, turn the knob clockwise or
counterclockwise to select the preferred temperature.
Do not interact with the thermostat for 5 seconds for the
thermostat to confirm the selection.
KONOse Quick Start Guide
2
