Johnson Controls HIDH018B21S, Engineering Manual

Page: 369 / 668

CONTROL SYSTEM
TC-15001-rev.3
6-53
3
Unit Number Setting
The indoor unit numbers are set by the auto-address function. Therefore, an indoor unit number setting
LVQRWUHTXLUHG,IWKHLQGRRUXQLWQXPEHULV¿[HGVHWWKHXQLWQXPEHURIDOOLQGRRUXQLWVUHVSHFWLYHO\DQG
VHULDOO\,WLVUHFRPPHQGHGWKDWWKHXQLWQXPEHUVHWWLQJVEHJLQZLWK³´7KHVHWWLQJLVVHWQRWWRRYHUODS
the unit number.
< Electrical Wiring Connecting and Setting >
1
Connection between Indoor Units
3HUIRUPWKHFRQQHFWLRQZRUNDVVKRZQEHORZ
2
Do not run the connected wireless controller cable and the power source cable (208/230V) in parallel in
the indoor units.
Stabilize the cable with plastic bands. Along with the wiring outside the indoor units, the control cables
should not run with the power source cable (208/230V). Keep a separation of more than 12 inches (30cm)
or run the cable through a grounded metal conduit.
OFF
ON
Unit Number Setting
DSW6 (Tens Digit) RSW1 (Units Digit)
1 2 3 4 5 6
Set No.1 pin ON.
OFF
ON
1 2 3 4 5 6
DSW6 RSW1
Ex.: Set for No. 16 Unit
Setting
Position Set by inserting
slotted screwdriver
into the groove.
Set at "6".
Factory setting for DSW6 and RSW1 were set to "0".
Max. 63 units are available for setting.
Indoor Unit No.1 Indoor Unit No.2 Indoor Unit No.3
Connecting Cable
(Accessory)
Wired Controller Cable
Control Cable
(No Polarity)
Power
Source
Cable
(208/230V)
IR Receiver Kit
For twin, triple or quad combinations,
a communication cable for the wireless
controller is not required. Use the field-supplied communication cable (AWG18)
for the wired controller cable. The total length
should be within 1640ft (500m). If the total length
is less than 98ft (30m), AWG22 cable can be sued.
< Power Source Cable 208/230V >
TB
1
TB
2
A B 1 2
L
1
TB
1
L
2
N
TB
2
A B 1 2
TB
2
A B 1 2
TB
1
L
1
L
2
N L
1
L
2
N