P5417050-rev.1
33
8.7 High Speed Setting
● This function is used to set the airflow volume higher than normal airflow volume. This is used for high
ceiling areas on site. Set the High Speed setting (1 or 2) from the function selection menu, depending
on the ceiling height as shown in the table below.
● If the "High-Speed 2" setting (02) is selected from the wired controller, airflow volume for
“HIGH 2” and “HIGH” will become equal because the airflow volumes for “HIGH 2” and “HIGH” both use
maximum fan speed.
8.8 Circulation Function at Heating Thermo-OFF*
This function maintains the fan operation by the set airflow volume at the heating Thermo-OFF. It is for
improvement of temperature distribution at sites with high ceilings.
*NOTE:
Thermo-ON: The outdoor unit and some indoor units are running
Thermo-OFF: The outdoor unit and some indoor units stay on, but don't run.
8.9 Individual Louver Settings (Number of Louver Outlets)
This setting is available only for the indoor unit adopting the individual louver. The number of individual
louvers (louver outlet numbers 1 - 2) are changeable as shown in the following procedures. The number
of individual louvers can be set when each of the louver outlets (louver outlet numbers 1 - 2) is set as the
louver outlet number 1.
Ceiling Height
High Speed Setting
Less than 10.2 ft. (3.1m)
Standard
10.2 ft. (3.1m)
High Speed 1
11.5 ft. (3.5m)
High Speed 2
Individual Louver Setting Procedure
1. Press and hold “Menu” during the normal mode (when
unit is operated).
The menu is displayed.
2. Select “Individual Louver Setting” from the Menu and
press “OK”.
The individual louver setting is displayed.
Menu
Motion Sensor Setting
Total Heat Exchanger SET
VENTI
Louver Open/Close
03
/
05
Individual Louver Setting
15:10(Fri)
Entr
Rtrn
Sel.
OK
Back
To Next Page
Follow the procedure in "Function Selection by Wired Controller" section for changing the setting.