25
All Rights Reserved. 2018
burner
adjustments
C
ONTINUED
It is possible to adjust the air shutter from below without dismantling the unit. The air shutter is located
directly behind the control valve for that burner.
Turn off the gas supply shutoff valve or close the main valve on the LP cylinder.
Ensure the oven control knobs are in the OFF position.
Rotate and move that corner of the oven to extend no more than 6 inches over the edge of the counter
top (Shown on page 22). Using a screwdriver loosen the lock screw(Page 24: B, F). Do not fully remove the
lock screw.
Once loose, you can rotate the air shutter to adjust the amount of air entering the venturi. Visually inspect that
the gas hose has not been stressed, dislodged or otherwise affected by moving the oven.
If it is safe to do so, and with the oven control knobs in the OFF position, turn on the gas supply valve or open
the main valve on the LP cylinder. Light the burner using the lighting steps on page 18. ONLY LIGHT THE
BURNER TO BE ADJUSTED.
Rotating the air shutter, adjust the amount of air entering the venturi.
For a lifting flame, slowly close the air shutter until the flame no longer lifts from the burner. For a sooty flame,
slowly open the air shutter until the flame burns cleanly.
Once a stable flame that burns cleanly and does not lift is found, turn the oven control knob to the OFF
position then tighten the lock screw. Re-light and confirm the adjustment is ok.
Turn the oven control knob to the OFF position. Turn off the gas supply shutoff valve or close the main valve
on the LP cylinder.
Return the oven to its normal position on the counter top making sure that the gas hose has not been
stressed, dislodged or affected by moving the oven during this process.
1
3
4
5
9
7
6
8
10
2
adjusting
the
air
shutter
Summary of Contents for Fuel Outdoor Pizza Oven
Page 4: ......
