•
The appliance can be installed as freestanding or below the kitchen
counter with correct space.
•
Do not install the appliance behind a lockable door, a sliding door
or a door with a hinge on the opposite side, where the appliance
door can not be fully opened.
•
Connect the mains plug to the mains socket only at the end of the
installation. Make sure that there is access to the mains plug after
the installation.
•
The ventilation openings in the base (if applicable) must not be
obstructed by a carpet.
•
Ensure you have good ventilation in the installation room to avoid
the back flow of gases into the room from appliances burning other
fuels, including open fires.
•
Exhaust air must not be discharged into a flue which is used for
exhausting fumes from appliances burning gas or other fuels (if
applicable).
•
The operating water pressure (minimum and maximum) must be
between 0,5 bar (0,05 MPa) and 8 bar (0,8 MPa).
•
Obey the maximum load volume of 8 kg (refer to the “Programme
chart” chapter).
•
The appliance is to be connected to the water mains using the new
supplied hose-sets. Old hose sets must not be reused.
•
If the supply cord is damaged, it must be replaced by the
manufacturer, its Authorised Service Centre or similarly qualified
persons in order to avoid a hazard.
•
Wipe away lint that has accumulated around the appliance.
•
Items that have been soiled with substances such as cooking oil,
acetone, alcohol, petrol, kerosene, spot removers, turpentine,
waxes and wax removers should be washed in hot water with an
extra amount of detergent before being dried in the wash dryer.
•
Do not use the appliance if industrial chemicals have been used for
cleaning.
•
Do not dry unwashed items in the wash dryer.
Washer Dryer User Manual
5
