Model EELR537A
Installation, Operation and Maintenance
Page
3
Rev. 09/16/2021
EELR537A-IOM.
doc
V
ERTICAL
C
LEARANCE
Check the height of the area where the lift is to
be installed. Clearance should be calculated
based on the full raised height of the lift.
Failure by purchaser to
provide adequate
clearance could result in
unsatisfactory lift performance, property
damage, or personal injury.
F
LOORING
Be certain you have the proper concrete floor to
properly handle the loaded lift. Floor should be in
generally good condition with no large cracks,
spalling or deterioration.
Minimum requirements for concrete are 4
inches minimum depth, with steel
reinforcement, 3500 psi, cured for 28 days per
local commercial practice
. Floor should be
level within 3/8 inch over the installation area. No
anchors should be installed within 8 inches of any
crack, edge, or expansion joint. If these
conditions cannot be met, a pad may be poured
to accommodate the lift.
Check with local building inspectors and/or
permits office for any special instructions or
approvals required for your installation.
A qualified person should be consulted to
address seismic loads and other local or state
requirements.
Failure by purchaser to
provide the
recommended mounting
surface could result in unsatisfactory lift
performance, property damage, or personal
injury.
L
OCATION
This lift has been evaluated for indoor use only
with an operating ambient temp. range of 5 –
40°C (41
–
104°F). Outdoor Installation is
Prohibited.
E
LECTRICAL
R
EQUIREMENTS
For lift installation and operation it is necessary to
have a dedicated circuit with circuit breaker or
time delay fuse. Refer to wiring diagram for
circuit sizing.
S
AFETY
N
OTICES AND
D
ECALS
For your safety, and the safety of others, read
and understand all of the safety notices and
decals included here.
R
EAD ENTIRE MANUAL BEFORE ASSEMBLING
,
INSTALLING
,
OPERATING
,
OR SERVICING THIS
EQUIPMENT
.
P
ROPER MAINTENANCE AND INSPECTION IS
NECESSARY FOR SAFE OPERATION
.
DO
NOT
OPERATE A DAMAGED LIFT
.
Safety decals similar to those shown here
are found on a properly installed lift. Be sure
that all safety decals have been correctly
installed on the columns as described in this
installation manual. Verify that all authorized
operators know the location of these decals
and fully understand their meaning. Replace
worn, faded, or damaged decals promptly.
Do not attempt to raise a
vehicle on the lift until the
lift has been correctly
installed and adjusted as described in this
manual.
WARNING
WARNING
WARNING
