John Bean 48109B, Installation And Operation Manual

Page: 8 / 40

8 of 40
6. INSTALLATION INSTRUCTIONS
When the lift arrives on site, please read the owner’s manual completely. Check the contents to
make sure no parts are missing before starting installation. Gather all the tools listed and make
sure the installation instructions are fully understood before commencing with the installation.
IMPORTANT: It is the user’s responsibility to provide a satisfactory installation area for
the lift. Lifts should only be installed on level concrete floors with a minimum thickness of
five (5) inches or 130 mm. Concrete must have a minimum strength of 4000 psi or 30 MPa
and should be aged thirty (30) days prior to installation. Please consult the architect,
contractor or engineer if doubt exists as to the strength and feasibility of the floor to enable
proper lift installation and operation.
It is the user’s responsibility to provide all wiring for electrical hook-up prior to installation
and to insure that the electrical installation conforms to local building codes. Where
required, it is the user’s responsibility to provide an electrical isolation switch located in
close proximity to the lift that will enable emergency stop capability and isolate electrical
power from the lift for any servicing requirements
.