I Use a single-phase alternating rated voltage supply. (Do not be used with a power supply exceeding
rated v
_ b110%.) I Use a power cord which is between 2mm
2
and 2.5mm
2
thick. (Cords other than 2mm
2
- 2.5mm
2
single-core cords cannot be used.)
(A drop in voltage is possible if the power cord exceeds 11 m in length, so we
recommend using a 2.5mm
2
cord.)
Wire the unit.
Embed the switchbox in the installation location (1 switchbox no cover) and
wire the power cord (with the green and yellow combined is ground line).
• If no switchbox is used, the power cord will be
pushed out, and prevent the unit from being
installed firmly against the wall.
Attach the installation panel to the wall using the 6
installation screws.
• If the wall is concrete, use commercially available
metal screw plugs (curl plugs, etc.).
• If the wall is not concrete, reinforce it before installation.
Installation Procedures
1. Remove the drain tank.
2. Remove the front panel.
(1) Remove the two screws.
(2) Remove all the front panel
chuckholes (3).
3. Remove the terminal box cover.
Remove the terminal box cover screw
and pull the cover out towards you.
Pull the separate line power cord into the unit and secure
inside.
Pull this machine has been with power cord. if you want to
change, please according to the following steps. (1) Pull the
power cord through the power cord hole on the rear of the
unit, attach the rear side to the 3 hooks on the installation
panel, and secure with the installation screws (temporarily
fixed on the unit side) while pushing the unit against the
wall lightly. • The installation screws for the unit will not
tighten completely if the hooks at the bottom of the installation
panel are not in place. Ensure the lower hooks are completely
hooked onto the rear of the unit.
Note:
Ensure the unit is hooked on the installation panel, tightened the
safety screws (at the low right), otherwise, this may cause the unit to drop
and be in the danger of theft.
Power socket
Power cord
Installation screw
Installation
panel
Lower hook
Stafety screw
Upper hook
Power cord
Drain tank
Front panel
Chuckhole
Screw
Terminal box
cover
Terminal box
Lock clutch
Nit
Screw
Lock clutch
GB