6
Joerns® Bed Frames
WeCare™ Bed
© 2022 Joerns Healthcare • 6110435 RevC • 22-2083
Assembly
Caution:
Carefully remove the packaging straps
(orange zip ties) before attempting to operate the bed.
Caution:
Prior to operation, refer to operating
conditions above to ensure bed electronics are within
ambient temperature.
Check that all parts of the bed were delivered and
inspect for damage.
Parts to Prepare:
a.
Head End Frame
b.
Foot End Frame
c.
Safety Pin (2)
d.
Actuator Pin and Clip (2 or 4)
e.
Pendant
f.
End panel(s)
Installation Of Bed Frame -Head and Foot
Tools required: None
Bed Frame Installation:
After cutting orange zip ties,
1.
Identify head frame and foot frame by compatible
ID labels on left side (Figure 1).
2.
Lay frame halves on soft surface feet side down.
Place packing material under head frame to make
assembly easier (Figure 2). Ensure the split frame
tubes are lined up (Figure 3).
Caution: Equipment Damage.
Failure to install the
actuators in the proper orientation may cause damage
to the actuators.
3. Install the back actuator and knee actuator on the
head frame and foot frame as shown using the
actuator pin and clip (Figure 4).
4. Insert head frame into foot frame and line up
pin hole.
5.
Insert safety pin on left and right sides, 2 pins total
(Figure 5). Be sure to route the actuator cables
through the nearest safety pin bail (Figure 6).
Figure 1
Figure 6
Figure 5
Figure 3
Figure 2
Figure 4
