CAUTION!
Do not remove the D-shaped shim washer from the gearcase clamp!
The shim washer prevents damage from over-tightening the tube damp screw.
a. Loosen the gear case clamp bolt.
b. Remove the index bolt from the gear case.
c. Side the gear case out of the tube. Using a grease gun, pump lithium-base
grease (about 10 grams) into the grease fitting on the gear case until you see old
grease being purged
from the gear case (Fig.HT15). Purged grease will be visible in the outer tube
cavity. Clean up the excess grease and then reassemble the gear case onto the
outer tube.
Make sure the index bolt fits into the hole on the outer tube. Securely tighten both
bolts.
1.Gear case Grease fitting
9.7 MAINTENANCE AND STORAGE for the WHOLE MULTIFUNCTION TOOL
Before any intervention on product, ensure that motor is off.
9.7.1 General Product Maintenance
Clean plastic parts with a soft clean cloth.
Do not use aggressive cleansers (solvents or abrasive cleansers), or an abrasive
sponge or sharp objects.
Do not put or immerse product in water or any other liquid.
9.7.2 Long Term Storage
Product must be stored in a dry location. Always lock up product and keep out of
reach of children Whenever the machine will not be used for 30 days or longer,
use the following procedures to prepare it for storage:
1. Clean external parts thoroughly and apply a light coating of oil to all metal
surfaces.
CAUTION!
Gasoline stored in the carburetor for extended periods can cause
hard starting, and could also lead to increased service and maintenance costs.
2.Drain all the fuel from the carburetor and the fuel tank.
