B. Cutter assembly for desired cutting angles
WARNING!
Do not touch the cutter blades when the
engine is running. The blades can oscillate even if the
engine is idling. The cutter assembly can be adjusted
to 10 different positions ranging from 120° to 270° from
the outer tube as shown in Fig.HT7. Refer to the steps
on the previous page for the adjustment procedures.
Always make sure the lock latch is securely locked
after each adjustment.
C. Cutter assembly for storage or transportation
WARNING!
Never run the engine when adjusting the cutter assembly to the
storage position.
1.With the engine stopped, install the cover onto the blade.
2.Using the procedures described on the previous page, rotate the cutter
assembly so it is parallel to the tube.
Make sure the latch lock and the latch release
return securely to a locking position.
See Fig.HT8.
3. Make sure the cover is in place on the
cutters before storing or transporting
9.4.3 Wearing the Strap
1.Hook the strap hook to the hanger on the outer pipe.
2.Wear the strap so that the hook stays at your right-hand side.
3.Adjust the length of the strap so that you can hold and operate the machine
comfortably.
Preparations
1.Wear suitable protective clothing and equipment-see section "Safety
Precautions".
2.Choose the best work position for safety against falling or projected object or
debris.
3.Start the engine,
4.Put on the strap.
5.Never stand directly underneath the branch you are cutting-be wary of failing
branches. Note that a branch may spring back at you after it hits the ground.
9.5 OPERATION
9.5.1 Intended use
- The product is intended for domestic use.
- The product is intended for trimming hedges
