right), scraps fly in the direction away from the body. You can avoid getting your
clothes dirty.
7.5 MAINTENANCE
7.5.1 Blades (Fig.BC9)
Sharpen each cutting blade after 25h of use and make sure the bottom corner is
rounded. Do not cool the blade with water in case of using a grinder. It may
cause cracks on blade.
7.5.2 Gear Case (Fig.BC10)
Supply multi-purpose grease at every 25 hours of use. Remove the cutter
holders to arrange for old grease to exit.
7.5.3 Before storage
Brushing off dirt form the machine, check damage or slack of each part. If
you find out abnormalities, have them repaired before the next use.
Extract fuel from the tank, and loose the drain screw of the float cabin to
extract fuel, turn on the engine, and leave it running until it stops naturally.
Remove the spark plug and put in 1-2cc of 2-cycle oil in the engine.
Draw the starter rope 2-3 times, set the plug back, and stop it at the
contraction position.
Apply anti-rust oil to the metal parts such as the throttle wire, put the cover
on the blade, and keep it indoor avoiding dampness.
