Jobsite CN-25, Original Instruction

Page: 33 / 39

Guide bar
• Reverse the bar occasionally to prevent partial
wear.
• The bar rail should always be a square. Check for
wear of the bar rail. Apply a ruler to the bar and the
outside of a cutter. If a gap is observed between
them, the rail is normal. Otherwise, the bar rail is
worn. Such a bar needs to be corrected or replaced.
(1) Ruler (2) Gap (3) No gap (4) Chain tilts
The table contains a list of all possible combinations between bar and chain,
indicating those which may be used on each machine, marked with the symbol “
*
”.
Pitch Guide bar
Chain saw
model
Length
Inches/c
m
Groove width
Inches/mm
CT2298
3/8” 12”/30cm 0.050”/1.3mm
*
For replacement use only above bars and chains. If you use non-approved
combinations it may cause serious personal injury and damage to the machine.
11. Storage
1. Empty the fuel tank and run the engine out of fuel.
2. Empty the oil tank.
3. Clean the entire unit.
4. Store the unit in a dry place out of the reach of children.
12. Waste disposal and environmental protection
Never pour remainders of chain lubricant or 2-stroke fuel mixture in the drain or