Jobsite CN-25, Original Instruction

Page: 18 / 39

pull the starter handle again to start the engine.
10. Pull up the front handle guard toward the front
handle to release brake. Then, allow the engine to
warm up with the trigger pulled slightly.
(1) Throttle trigger
(2) Rear handle
(3) Throttle trigger lock lever
Before you start the engine, make sure the saw
chain is not contacting anything. Make sure the
chain brake always is activated before each
starting.
■
CHECKING OIL SUPPLY
After starting the engine, run the chain at medium
speed and see if chain oil is scattered off as
shown in the figure.
Chain oil
The chain oil flow can be changed by inserting a
screwdriver in the hole on bottom of the clutch
side. Turn the shaft counter-clockwise to increase
the oil flow. Turn the shaft clockwise to decrease
the oil flow. Adjust according to your work
conditions.
(1) Chain oil flow adjusting shaft
The oil tank should become nearly empty by the
time fuel is used up. Be sure to refill the oil tank
every time when refueling the saw.