JOBO JOBOBIKE Bruno, Owner'S Manual

Page: 39 / 48

Error code Detection Your bike is equipped with an error detection system integrated into the display and controller. In the case of an elec-
tronic control system fault, an error code should display. The following error codes are the most common and can aid troubleshooting. If
your bike has an error code displayed at any time, it is recommended that you cease operation and contact JOBOBIKEs immediately.
Error code Definition Solution
07 High voltage protection 1. Remove and re-insert the battery to see if it resolves the problem. 2. Use the
BESST tool to update the controller.
3. Change the battery to resolve the problem.
08 Fault with motor hall sensor inside 1. Check if all connectors from the motor are correctly connected.
2. If the problem still occurs, please change the motor.
09 Error with the Engine’s phases Please change the motor.
10 The motor temperature reachesthe max protection
value
1. Turn off the system and allow the Pedelec to cool down.
2. If the problem still occurs, please change the motor.
11 The temperature sensor inside the motor has an er-
ror Please change the motor.
12 Error with current sensor inside controller Please change the controller or contact your supplier.
14 The protection temperature inside the controller
has reached its maximum protection value
1. Allow the pedelec to cool down and then restart the system.
2. If the problem still occurs, please change the controller or contact your supplier.
15 Error with the temperature sensor inside the con-
troller 1. Allow the pedelec to cool down and restart the system.
2. If the problem still occurs, please change the controller or contact yoursupplier.
38