5
Group 2 – Torque the Chassis Brackets
2:1
Inspect and make sure that all shims for the chassis's fastening brackets, where
applicable, are not loose and correctly positioned.
NOTE:
Before the chassis brackets are first fastened, during assembly, the gap
between them is measured, as shown below. If the gap is greater than 2 mm, shims
are placed in between them before torquing of the bolts.
2:2
Check
all
of the chassis’s fastening brackets and make sure that all bolts are correctly
torqued. Use the toque settings listed below in Table 2 for all bolts, except head bolts.
For head bolts, use a torque value of 40 Nm.
Thread (Metric)
Class 8.8
Class 10.9
M14
128 Nm
181 Nm
M16
197 Nm
277 Nm
Table 2: Torque setting for chassis brackets
Provide below are some examples of the chassis brackets. The actual brackets used
may be different to those shown, however the torque settings are the same.
Service Instruction: EcoDrive | 13301 Edition 1b | 2019-02-31
Summary of Contents for EcoDrive Hook-Lift L
