level probe.
A7
：
OFF
：
With water fow sensor, if it detected no water fow, the heater will not work.
ON
：
Without water fow sensor, could be equipped with any other manufacturer’s heater.
A8
：
OFF
：
With Ethink control panel.
ON
：
With JNJ control panel.
B1
：
OFF
：
Normal mode.
ON
：
Testing mode.
B2
：
OFF
：
With radio function.
ON
：
Without radio function.
B3
：
OFF
：
The maximum working time for surfing pump and blower is 25 minutes.
ON
：
The maximum working time for surfing pump is 60 minutes and the blower
working time is 20 minutes.
Ⅶ
. Warning and Error code hinting
1.
For the family which sharing facility with others, the user have to provide an emergency switch
while doing installation. And the user should easy to get access for the switch, the switch need
to be installed at least 1.52m far away, it is near to the system and not out of sight.
2.
The wire must be replaced if any damage occurred.
3.
Please shut down the power supply while repairing or installing any parts or wires.
4.
In order to prevent electric shock or water permeation, all the wire plug connector must be
blocked and not exposed.
5.
The system must be far away from infammable material or goods.
6.
When the system is showing any error code, please don’t use spa and go into water.
6.1 “E1”: The temperature sensor is short or open.
6.2 “FF”: The system detected that the temperature inside heater reach or over 48
℃
9
WARNING
1.Don’t open spa’s package before installation
2.Don’t stock spa under sunshine directly
3.Don’t cover spa with transparent film under sunshine
4.Spa must be filled with enough water or lid spa cover if spa is under sunshine
Attention: Spa problem or damage caused by customer’s transportation, stock, improper installation,
improper use, is out of manufacturer’s warranty
Notice: 1.Spa must be filled with enough water and have power supply if it’s installed
2. Spa must lid spa cover or other suitable cover if spa is not used.
