INSTALLATION MANUAL / MI0216.1
www.jnf.pt
40/44
INSTALLATION INSTRUCTION
MOTOR DRIVER
LED STATUS
SITUATION/PROBLEM
REMARKS
ORANGE LED
blinking
Bluetooth communication problem
between the I/O accessories control
panel and the motor driver.
º Check the power supply to the driver.
º Loss of communication caused by a
temporary power failure or power drop
on the power supply board.
º The Bluetooth pairing of the two
control panels did not succeed.
º The Bluetooth pairing took more than
2 minutes. Disconnect other bluetooth
devices near the guide and try again.
º Repeat the self-adjustment
(switch OFF > wait 10s > switch ON).
º Check motor power supply.
º Check that all brushes are in direct
contact with the top and bottom rails.
º Check the status of the top and bottom
rails. Remove any particles of dust
using a dry cloth. Do not use liquids.
º Check if dip switch #2 on the motor
driver, used for bluetooth pairing is in
the correct position.
º When setting the dip switch to ON, you
must listen a “click” sound indicating
that the dip switch is firmly placed in
position. Then run a new pairing
process.
Power supply problem on the motor.
After replacing any of the two control
boards (I/O accessories or motor
driver), there is no communication
between them. Pairing process fails.
All LEDs
are off
MOTOR DRIVER
Bluetooth LED
B
- BLUE
RED GREEN ORANGE
RED
Operation Mode LEDs