INSTALLATION MANUAL / MI0216.1
www.jnf.pt
34/44
INSTALLATION INSTRUCTION
6.CONFIGURATION
6.3. Self-adjustment
(FIRMWARE I/O V3.1.X / DR 20.1.X)
POWE
R
LED
BLUETOOTH
(BLUE)
Pairing butto
n
I/O Accessorie
s
Driver
DRIVER DIP SWITCHES
MASTER DIP SWITCHES
(GREEN)
RED
GREEN
RED
ORANGE
Operating mode LED
s
ON/OFF
SWITCH
12
34
ON
OFF
1
2
3
4
1
2
32
11
2
OFF
ON
RX
TX
1. SWITCH OFF the operator (the ON/OFF switch is located on one side of the I/O accessories board).
2. Set dip
switch nº4
on the motor Driver to
OFF
position (parameter learning).
3. Wait 10 seconds, and SWITCH ON the operator.
4. The bluetooth led (blue) will turn on indicating that the two control panels are in the process of
being paired, and the motor will start moving to run a self-adjustment. At a point, the door will
stop for a few seconds, and then start moving at low speed. Do not touch or interfere, as this
stop & go is part of the process to calculate the leaf weight. Wait until the door stops fully. The
full process may take 1 to 3 cycles (30 to 120 sec), depending on the door position at start.
5. The self-adjustment is finished when the the Bluetooth led is OFF (control panels are paired) and
the door stops moving.
6. Set Dip
switch no. 4
on the motor Driver to
ON
position to
save
the parameters in memory.
7. SWITCH OFF, wait until all leds on driver are off and then SWITCH ON again.
8. Tight the nut next to the motor to make the final adjustment (check figure bellow).
Before running the self-adjustment, set the dip switches (opening direction,
speed, etc) in the desired position on I/O Acces. and Driver.
Please refer to the installation manual
DO NOT INTERFERE OR TOUCH THE DOOR LEAVES DURING SELF-ADJUSTMENT
.
2
4
1
2